Below are the available bulk discount rates for each individual item when you purchase a certain amount
- Buy 5 or above and get 10% off
Japanese made nickel-silver fret wire, in 50cm pre-radiused lengths. Most new necks require 150cm (3 lengths). We put a tight radius on these lengths so they will work on any radius fingerboard, from flat to tight. Being over-radiused helps prevent the ends of the wire from popping back out when fitted. Six sizes are available, please check carefully what you need before ordering. As a guideline, the following sizes work for the following brands:
A 2.00 x 0.90mm Martin
D 2.40 x 1.40mm Gibson
E 2.62 x 1.17mm Fender
This isn't a guarantee, just a suggestion!
The full dimensions, in mm, are:
|Model||Crown Width||Crown Height||Total Height||Tang Width||Tang Width inc Studs|
Posted by Gerard Fahy on 18th Jan 2017
I don't have a lot of experience with fretwire but this is pretty good - much harder than the original frets on the (admittedly crappy) Chinese made neck I was working on.